Fake grass will prove to be the best option to completely remodel your outdoor space, whether you've removed a section of lawn or vegetation or are simply starting with a blank slate for your garden design. Want to lay fake grass on dirt? To enjoy your new artificial lawn for years without having to perform any care, it is imperative that you thoroughly prepare the ground before beginning the installation. There is absolutely no difficulty in spreading artificial grass on any kind of soil, but you must adhere to the groundwork regulations. It is crucial to have a level, permeable surface. Prepare to cover the soil with fake grass. In this article, you will find out to lay fake grass on dirt.
Materials Checklist
- Weed membrane
- Type 1 aggregate
- Sand with edges for fine leveling
- Metal or wooden frame (optional)
- fake grass of your choice
- Underlay shock pad 20 mm
- 40 x 2.5 mm carpet bolts
- adhesive for artificial grass
- adhesion tape (if joints are required)
- Dry sand
Tools Checklist
- Shovel
- Wheelbarrow
- Plate Wacker
- Scratch bar
- rigid broom
- Straight edge or measuring tape
- a razor-sharp knife and extra blades
- knife or a spatula for filling
Before you start :
Do The Groundwork: When installing fake grass on top of dirt, preparation is likely the most crucial step. Look for cables or pipelines before you begin. You won't want to do any harm or block access to necessary services for your property. Next, make sure there is adequate drainage in the area where artificial grass will be installed.
After that, apply a potent weed killer to the area. Give this plenty of time to work for at least a few days.
You can now go to the following phase. Remove the soil between 75 and 100 mm deep. After removing any dead vegetation, level the land to create a flat surface. Be advised that differences will probably show through your freshly installed artificial grass. However, a small gradient is allowed because it would improve drainage.
You are now prepared to install your weed membrane because you have a flat soil surface. This will prevent weeds from ruining your lawn's aesthetic attractiveness.
You can now install your optional theme. If you want to plant a border around the synthetic lawn, we advise using a metal or wood surround. Make sure it doesn't extend past the very last grass line.
Last but not least, cover the area with type 1 aggregate to a depth of roughly 60mm. Apply a layer of sharp sand after compacting the aggregate using a wacker plate. To level everything out, use a leveling bar.
Step-By-Step Guide On Installing Fake Grass On Dirt
Step-1- Install Your Shock Pad Underlay
Your artificial grass will last longer and feel more natural to walk on with underlay installed. Push the underlay roll as close to the edge or perimeter as possible as you start at one end of the area to be covered. Cut it into the appropriate shape after rolling it out. Continue until you have covered the entire area.
Push the underlay roll as close to the edge or perimeter as possible as you start at one end of the area to be covered. Cut it into the appropriate shape after rolling it out. Continue until you have covered the entire area.
To attach any separate underlay pieces, use jointing tape. Create one sheet that you may fix down around the edge of your soil area. Place bolts every 10 to 20 cm to keep things in place.
2)Install Your Synthetic Turf
The area that has to be covered should be covered with your fake grass. To provide a clean edge when trimming to size, allow 5 cm extra around the borders. Allow the synthetic turf to rest for at least two to three hours to allow the wrinkles to disappear. You can start trimming it to size and pinning it down once it is clear of creases.
Pieces of fake grass may occasionally need to be joined. Never apply adhesive to the underlay directly from individual pieces. Walking on these will cause them to move independently, exposing the joints
3)Sand And Brush The Synthetic Grass
It is a process that minimizes the possibility of ripples emerging by keeping the fake turf in place. Additionally, it maintains the artificial grass fibers erect and protects them. Sand that is weed-free is best for preventing vegetation. Sprinkle over the grass and then give the fibers a good lift with a stiff or motorized broom stroked in the pile's direction.
Following Fitting:
- A stiff brush or plastic rake can be used to maintain the appearance of artificial grass.
- To remove debris, use a leaf blower, broom, or leaf rake. To clean up spills, use water.
- Try to distribute the weight of garden furniture or children's playthings as evenly as you can while setting them on the synthetic grass to prevent dents.
- Barbecues and other hot items should never be placed on artificial grass.
Read more -
How To Lay Artificial Grass? – The Complete Guide To Everything About Artificial Lawn Installation